1. The multi-functional design for spray granulation and pellet coating.
2. External spray gun is easy to be observed and adjusted.
3. The rotary table design makes the coating uniformity and high roundness, particle damage will not happen.
4. High permeability, drying rate is better than centrifugal coater.
5. Rotary table of different air permeability is changeable according to different process condition.
6. Solution volume of the spray gun can be adjusted according to the loading capacity.
7. Easy to discharge.
8. Coated pellet density is higher than the bottom spray (WURSTER).
9. Pellet coating procedure is faster than bottom spray coating (WURSTER), less material loss.

1. The Roller Compactor is designed to have 3 functions in one unit. These are compression, milling, and granulating. It is a simpler operation than wet granulation (mixing, pasting, kneading, drying, sifting, and granulation etc.)
2. No water or other liquid is added, so the loss of active ingredients due to decomposition can be eliminated. Highly stable granules can be obtained.
3. Feeding Hopper can move up and down by the inbuilt hydraulic system for ease of maintenance and cleaning.
4. Charging screw and roller speed are designed for precise and variable adjustment.
5. The pressure of hydraulic system is adjustable to accommodate a wide range of materials.
6. Wide ranges of screen mesh size are available for the granulator screen......

1. Follow the regulations of cGMP, PIC/S GMP, FDA
2. WIP System is available
3. Explosion Proof System is available: Suitable for organic solvent
4. Multi-safety Interlock System:
a. Stop operation when the cover is not closed properly
b. Stop operation when the air pressure is not sufficient for the seal
5. Separated compressed air routes design to meet the good air quality: the compressed air for air seal will pass through an air filter. For the cylinder, the compressed air will pass through lubricating oil to ensure the air quality and lubrication
6. Unique design of the air seal: This design can prevent powder access into the main seal and the chopper to prevent powder dropping
7. The clearance between impeller and the bottom of mixing bowl is only about 0.5_0.8 mm_ therefore, high mixing efficiency can be achieved

1. Follow the requirements of cGMP、PIC/S、21CFR Part 11
2. Using high-sensitivity CMOS CCD to take high-resolution images. Inspect hair and foreign objects, adhesion of dirt and foreign matters, improve the detection accuracy of the edge of the tablet.
3. High-speed image processing technology to improve the quality of inspection process and save manpower.

1. Computer control, manual / automatic operation.
2. Linear velocity of tablet is 85 cm / min (maximum).
3. The machine can be used for bi-color and monochrome tablets. Tablet diameter is from Ø6mm to Ø12mm, thickness is from 5mm to 9mm.
4. The working time of the laser drilling machine CO2 is about 30,000 hours, drilling aperture adjustable (the smaller the aperture, the longer working hours of CO2, laser drilling machine work area ranges: H50mm X W50mm X H4 mm).
5. The device system including: vibrating hopper, centrifugal alignment supply mechanism, flat transport mechanism, indexing plate mechanism, laser drilling mechanism, image discrimination sensor, RGB color identification system, CCD camera detection system and discrimination discharge mechanism.
6. Automatically detect tablets surface: According to the tablet color to determine drug layer or push layer. The tablet with drug layer up will be send to the conveyor.
7. Automatic checked one by one: drilling, pore size, pore deviation.
8. The system complies with CFR21 Part11 and GAMP5.